From lot to scheme book.

Enter your lot, setbacks, and program — SiteShaper draws the site plan, generates schematic floor plates (with MEP locations on single-family), and assembles a printable scheme book your architect can review, redline, and build from. Schematic design intent — not construction documents.

1
Shape the siteLot dimensions, setbacks, and where the building sits — the envelope draws itself.
→
2
Set the programSingle-family, townhomes, or multifamily — beds, units, stories, parking.
→
3
Get the scheme bookSite plan, floor plates, MEP markers, numbers table — print it and hand it over.
Juniper Court — a two-story 4-bed/2.5-bath with a 2-car garage on a 62×125 lot. Explore the plates and MEP markers, then reshape it into your project.
Width (street frontage)
Depth
Front
Sides (each)
Rear
Bedrooms
Baths
Stories (1–2)
Garage
Leave as suggested or set your own; excludes garage.
Spaces per unit / home
Layout
Extra push-back from front (ft)
Shift left(−)/right(+) (ft)

Schematic design intent only. Not architectural, engineering, or MEP design; not for permitting or construction. Confirm all dimensions, codes, and requirements with your licensed design professionals and jurisdiction. Nothing you enter leaves this device.